Guide

Is My House Suitable for an Air Source Heat Pump?

Most UK homes can take a heat pump, but suitability depends on heat loss, radiators, cylinder space and outdoor siting. Work through the checks before you ask for quotes.

Illustration of a house outline with a magnifying glass over it, a checklist with ticks and a space marked beside the wall for an outdoor unit

Many UK homes can take an air source heat pump, including older ones. Age alone doesn't decide it. What matters is how much heat the house loses, whether the radiators or floors can deliver that heat at a lower water temperature, and whether there's room for the equipment. You can check most of this yourself before paying anyone.

Work through these checks in order

Each check below is a question a surveyor will ask. None of them is a hard yes or no on its own. A 'no' usually means extra work and cost rather than a closed door.

1. How much heat does the house lose?

Insulation in the loft and walls, glazing and draughts all feed into heat loss. A well-insulated home needs a smaller unit and a lower running cost. A leaky one isn't ruled out, but the design has to account for it, and fixing the worst gaps first can be cheaper than buying a bigger machine. The room-by-room calculation is done in a heat loss survey.

2. Can your radiators or floors do the job?

Heat pumps run the heating water cooler than a gas boiler does, so radiators often need to be larger to give out the same heat. Underfloor heating suits heat pumps well. Each radiator should be compared with its room's heat loss at the planned water temperature. Some stay, some get bigger, and a few may be replaced. Don't assume every radiator has to go.

3. Is there space inside?

A heat pump needs a hot water cylinder, and it's usually bigger than anything a combi boiler home has had. Check whether there's a cupboard, loft or utility space with enough floor area and height. Pipework runs matter too: microbore pipes need assessing for flow and pressure loss, though their presence doesn't automatically mean a full repipe.

4. Is there space outside?

The outdoor unit needs clear airflow, a firm base and a short, practical pipe route. Think about bedroom windows, neighbours' boundaries, drainage and access for servicing. Planning rules vary between UK nations and depend on the property. Don't assume a neighbour's installation means yours is permitted. Flats, listed buildings and conservation areas often need extra checks, so confirm the position with your local planning authority and read the Planning Portal guidance for England.

5. Is the electricity supply up to it?

The installer checks the supply, the consumer unit and whether a new circuit is needed. This is a common source of extra cost, so ask for it to be itemised.

A quick self-check

Gather your loft insulation depth, glazing type, radiator count and sizes, the cylinder space available and a photo of the proposed outdoor spot. Handing these to an installer speeds up the first conversation. They don't replace the survey.

What to do once you've checked

If most answers look workable, the next step is a proper survey, which our heat loss survey cost guide prices. If you're weighing a heat pump against keeping a boiler, read heat pump vs gas boiler. Then compare quotes through installation.

How to check whether your house suits a heat pump

  1. Note your insulation and glazing

    Record loft insulation depth, wall type, glazing and any known draughts. These shape how much heat the house loses.

  2. List your radiators

    Count the radiators and note their sizes. Check whether any rooms already struggle to warm up, and whether underfloor heating is fitted.

  3. Find cylinder space

    Look for a cupboard or loft area with enough floor area and height for a hot water cylinder.

  4. Pick an outdoor spot

    Choose a position with clear airflow, a firm base and a short route for pipework, away from neighbours' boundaries and bedroom windows.

  5. Check planning and access

    Confirm the planning position for your property and nation, and note whether the spot can be reached for servicing.

  6. Book a heat loss survey

    Share what you found and ask for a room-by-room heat loss survey before you compare prices.

Frequently asked questions

Can an older house use a heat pump?

Possibly. Building age alone doesn't decide suitability. Heat loss, insulation, radiator capacity, available space and the predicted running costs need to be assessed together.

Do I need underfloor heating for a heat pump?

No. Underfloor heating suits low water temperatures, but many homes use radiators, some of them larger than before. A survey compares each radiator with its room.

Does a heat pump work without a hot water cylinder?

Most systems need a cylinder suited to a heat pump to supply hot water. Space for it is one of the first things a surveyor will check.

Do I need to insulate before installing a heat pump?

Not always, but cutting heat loss can reduce the size and cost of the unit. Ask the surveyor which improvements make the biggest difference.

Ready to talk to an air source heat pump installation specialist?

Get Free Quotes →